Fire & Life Safety (Focus On Preparation and Prevention)

Monitoring Technology

Monitoring TechnologyIn a previous column I discussed implementing technology to reduce inspection times and increase staff time to tackle other life-safety issues on your campus. I don’t often dedicate another article so soon to a subject recently covered; however, I am breaking this rule. I want to revisit monitoring technologies available for fire extinguishers, electrical panels, coolers and egress systems and their ability to reduce inspection citations from fire or OSHA regulators.

Common Violations

I just returned from a conference where fire prevention and OSHA regulators were in attendance. During a break the topic of common violations between fire inspections and OSHA inspections came up. The discussion determined that obstructed extinguishers, electrical panels and exit routes — as well as fire extinguishers not being inspected on a monthly basis — were in the top ten, most frequently cited violations. Both fire and OSHA staff indicated that it is assumed that it is possible to always find an obstructed extinguisher or one that has not received its monthly or yearly inspection.

The OSHA inspector indicated that first-time offenses for violating an OSHA regulation are capped at $7,000, unless it is found to be a willful violation. A repeat violation increases the penalty to $70,000. The inspector was quick to rattle off locations where fines exceeded $233,000 and $144,000 for repeat violations.

I shared with both inspectors that there is technology that can eliminate first time violations for extinguisher, exit system and electrical panel obstructions as well as missed monthly inspections. I told them about a location that had installed 14 monitored points covering extinguishers, electrical panels and a temperature sensor alarm in a pharmacy refrigerator. The devices were part of a seven-month facility test to demonstrate that active monitoring of these locations would reduce or eliminate obstructed devices and, in the case of the temperature sensor, protect extremely costly medicine.

The fire extinguisher monitoring devices can produce an alert and a trouble signal. The alert signal is produced when the extinguisher is removed from is designated location (This also cuts down on tampering.). The trouble signal is activated when the extinguisher, exit or electrical panel is obstructed. The trouble signal is also activated when there is abnormal pressure in the extinguisher.

Proof of Effectiveness

Data gathered from the seven months clearly showed the benefits of the monitoring technology. During the first four months all the fire extinguisher monitoring devices had at least one obstruction trouble alarm, and several had multiple troubles. At first the obstruction troubles were concerning, but after the first few months the obstruction troubles became less frequent. Employees went through a learning curve and then realized obstructions were not going to be overlooked.

The inspectors both agreed that these violations are low-hanging fruit, and with monitoring technology any school can eliminate the need for inspectors to cite for obstructions and improper inspections. One of the inspectors mentioned a joint commission inspector who said that extinguishers are expected to be written up regardless if it’s only one unchecked extinguisher and you have 1,000.

It’s a 100 percent compliance item — 99.9 percent could be in compliance — you will still be cited. Installing monitoring technology takes hundreds or thousands of points of regulatory risk down to no points of risk for monitored locations. You now engineer out one of the simplest items for an inspector to question or observe a deficiency. In addition your egress routes, electrical panels and extinguishers are all accessible for use in an emergency.

One inspector asked if the technology to monitor these items is available from multiple companies. Yes, it is. All major fire alarm companies have the ability to install this equipment.

This article originally appeared in the December 2015 issue of College Planning & Management.

About the Author

Mike Halligan is the President of Higher Education Safety, a consulting group specializing in fire prevention program audits, strategic planning, training and education programs and third party plan review and occupancy inspections. He retired after twenty six years as the Associate Director of Environmental Health and Safety and Emergency Management at the University of Utah. He frequently speaks and is a recognized expert on residence hall/student housing fire safety and large scale special event planning. He also works with corporate clients to integrate products into the campus environment that promote safety and security.

Share this Page


Dude Solutions Is Back with More Data in Their 2018 Operations Health Index

See how your industry peers reported on the current state of their operations and get insight into how you can use the information to improve yours in Dude Solutions' 2018 Operations Health Index.

Subscribe to CP&M E-News

College Planning & Management's free email newsletter keeping you up-to-date and informed.

I agree to this sites Privacy Policy.